Dell PowerConnect FCS624S Configuration Guide - Page 1176

31 Configuration examples NOTE When you configure a Backup router, the router interface on which you are configuring the VRID must have a real IP address that is in the same subnet as the address associated with the VRID by the Owner. However, the address cannot be the same. The priority parameter establishes the router VRRPE priority in relation to the other VRRPE routers in this virtual router. The track-priority parameter specifies the new VRRPE priority that the router receives for this VRID if the interface goes down. Refer to "Track ports and track priority" on page 1105. The activate command activates the VRID configuration on this interface. The interface does not provide backup service for the virtual IP address until you activate the VRRPE configuration. Alternatively, you can use the enable command. The activate and enable commands do the same thing. Syntax: router vrrp-extended Syntax: ip vrrp-extended vrid Syntax: backup [priority ] [track-priority ] Syntax: track-port ethernet [/] | ve Syntax: ip-address Syntax: activate 1134 PowerConnect B-Series FCX Configuration Guide 53-1002266-01