Dell PowerConnect FCS624S Configuration Guide - Page 177

Managing your IronStack 5 S8:M2 FCX-1XG 1-port 16G Module (1-XFP) S8:M3 FCX-1XG 1-port 16G Module (1-XFP) PowerConnect(config)# OK 1 0012.f2eb.d570 OK 1 0012.f2eb.d571 Syntax: show module Table 27 describes the fields displayed in this output example. TABLE 27 Field definitions for the show module command This field... Describes... Module Status Ports Starting MAC Identifies the module, by stack unit ID, module number, module type The status of this module The number of ports in this module The starting MAC address for this module Displaying stack resource information Use the show stack resource command to display stack resource information, as shown in this example. PowerConnect# show stack resource alloc in-use avail get-fail register attribute 2400 2347 53 0 general 12B data 32 8 24 0 RB-tree node 4096 2347 1749 0 PowerConnect# limit get-mem size init 556800 3089 142 2400 7424 8 12 32 237568 2702 18 1024 Syntax: show stack resource Table 28 describes the output fields for this command. TABLE 28 Field definitions for the show stack resource command This field... Describes... This command displays the following information for register attributes, general 12B data, and RB-tree node alloc Memory allocated in-use Memory in use avail Available memory get-fail The number of get requests that have failed. limit The maximum memory allocation get-mem The number of get-memory requests size The size init The number of requests initiated. Displaying stack information You can display information about any and all of the members in an IronStack by entering show commands from the Active Controller console port. If you enter show commands from a unit that is not the Active Controller, the information may not be displayed correctly. PowerConnect B-Series FCX Configuration Guide 135 53-1002266-01