Dell PowerConnect FCS624S Configuration Guide - Page 405

Virtual Switch Redundancy Protocol (VSRP) 10 FIGURE 73 Track port priority subtracted during priority calculation Configured priority = 100 Track priority 20 Actual priority = (100 - 20) * (3/3) = 80 Configured priority = 100 Actual priority = 100 * (3/3) = 100 X VSRP Backup optional link VSRP Master Track link is down B BB FF F VSRP Aware VSRP Aware VSRP Aware MAC address failover on VSRP-aware devices VSRP-aware devices maintain a record of each VRID and its VLAN. When the device has received a Hello message for a VRID in a given VLAN, the device creates a record for that VRID and VLAN and includes the port number in the record. Each subsequent time the device receives a Hello message for the same VRID and VLAN, the device checks the port number: • If the port number is the same as the port that previously received a Hello message, the VSRP-aware device assumes that the message came from the same VSRP Master that sent the previous message. • If the port number does not match, the VSRP-aware device assumes that a VSRP failover has occurred to a new Master, and moves the MAC addresses learned on the previous port to the new port. The VRID records age out if unused. This can occur if the VSRP-aware device becomes disconnected from the Master. The VSRP-aware device will wait for a Hello message for the period of time equal to the following. VRID Age = Dead Interval + Hold-down Interval + (3 x Hello Interval) The values for these timers are determined by the VSRP device sending the Hello messages. If the Master uses the default timer values, the age time for VRID records on the VSRP-aware devices is as follows. 3 + 2 + (3 x 1) = 8 seconds In this case, if the VSRP-aware device does not receive a new Hello message for a VRID in a given VLAN, on any port, the device assumes the connection to the Master is unavailable and removes the VRID record. PowerConnect B-Series FCX Configuration Guide 363 53-1002266-01