Dell PowerConnect FCS624S Configuration Guide - Page 1289

Displaying 802.1X information 34 Enabling 802.1X accounting To enable 802.1X accounting, enter the following command. PowerConnect(config)#aaa accounting dot1x default start-stop radius none Syntax: aaa accounting dot1x default start-stop radius | none radius - Use the list of all RADIUS servers that support 802.1X for authentication. none - Use no authentication. The client is automatically authenticated without the device using information supplied by the client. NOTE If you specify both radius and none, make sure radius comes before none. Displaying 802.1X information You can display the following 802.1X-related information: • The 802.1X configuration on the device and on individual ports • Statistics about the EAPOL frames passing through the device • 802.1X-enabled ports dynamically assigned to a VLAN • User-defined and dynamically applied MAC address filters and IP ACLs currently active on the device • The 802.1X multiple-host configuration Displaying 802.1X configuration information To display information about the 802.1X configuration on the Dell PowerConnect device, enter the following command. PowerConnect#show dot1x PAE Capability: Authenticator Only system-auth-control: Enable re-authentication: Disable global-filter-strict-security: Enable quiet-period: 60 Seconds tx-period: 30 Seconds supptimeout: 30 Seconds servertimeout: 30 Seconds maxreq: 2 re-authperiod: 3600 Seconds Protocol Version: 1 Syntax: show dot1x The following table describes the information displayed by the show dot1x command. PowerConnect B-Series FCX Configuration Guide 53-1002266-01 1247