Dell PowerConnect FCS624S Configuration Guide - Page 1296

34 Displaying 802.1X information The all keyword displays all dynamically applied IP ACLs active on the device. Specify the variable in the following formats: • PowerConnect B-Series FCX stackable switches - Displaying the status of strict security mode The output of the show dot1x and show dot1x config commands indicate whether strict security mode is enabled or disabled globally and on an interface. Displaying the status of strict security mode globally on the device To display the status of strict security mode globally on the device, enter the following command. PowerConnect#show dot1x PAE Capability: Authenticator Only system-auth-control: Enable re-authentication: Disable global-filter-strict-security: Enable quiet-period: 60 Seconds tx-period: 30 Seconds supptimeout: 30 Seconds servertimeout: 30 Seconds maxreq: 2 re-authperiod: 3600 Seconds security-hold-time: 60 Seconds Protocol Version: 1 Syntax: show dot1x Displaying the status of strict security mode on an interface To display the status of strict security mode on an interface, enter a command such as the following PowerConnect#show dot1x config e 1/3 Port 1/3 Configuration: Authenticator PAE state: AUTHENTICATED Backend Authentication state: IDLE AdminControlledDirections: BOTH OperControlledDirections: BOTH AuthControlledPortControl: Auto AuthControlledPortStatus: authorized quiet-period: 60 Seconds tx-period: 30 Seconds supptimeout: 30 Seconds servertimeout: 30 Seconds maxreq: 2 re-authperiod: 3600 Seconds security-hold-time: 60 Seconds re-authentication: Disable multiple-hosts: Disable filter-strict-security: Enable Protocol Version: 1 Syntax: show dot1x config ethernet Specify the variable in the following formats: 1254 PowerConnect B-Series FCX Configuration Guide 53-1002266-01