Dell PowerConnect FCS624S Configuration Guide - Page 960

28 Displaying CPU utilization statistics TABLE 173 CLI display of RIP filter information This field... Displays... Route filters The rows underneath "RIP Route Filter Table" list the RIP route filters. If no RIP route filters are configured on the device, the following message is displayed: "No Filters are configured in RIP Route Filter Table". Index The filter number. You assign this number when you configure the filter. Action The action the router takes if a RIP route packet matches the IP address and subnet mask of the filter. The action can be one of the following: • deny - RIP route packets that match the address and network mask information in the filter are dropped. If applied to an interface outbound filter group, the filter prevents the router from advertising the route on that interface. If applied to an interface inbound filter group, the filter prevents the router from adding the route to its IP route table. • permit - RIP route packets that match the address and network mask information are accepted. If applied to an interface outbound filter group, the filter allows the router to advertise the route on that interface. If applied to an interface inbound filter group, the filter allows the router to add the route to its IP route table. Route IP Address The IP address of the route destination network or host. Subnet Mask The network mask for the IP address. Neighbor filters The rows underneath "RIP Neighbor Filter Table" list the RIP neighbor filters. If no RIP neighbor filters are configured on the device, the following message is displayed: "No Filters are configured in RIP Neighbor Filter Table". Index The filter number. You assign this number when you configure the filter. Action Neighbor IP Address The action the router takes for RIP route packets to or from the specified neighbor: • deny - If the filter is applied to an interface outbound filter group, the filter prevents the router from advertising RIP routes to the specified neighbor on that interface. If the filter is applied to an interface inbound filter group, the filter prevents the router from receiving RIP updates from the specified neighbor. • permit - If the filter is applied to an interface outbound filter group, the filter allows the router to advertise RIP routes to the specified neighbor on that interface. If the filter is applied to an interface inbound filter group, the filter allows the router to receive RIP updates from the specified neighbor. The IP address of the RIP neighbor. Displaying CPU utilization statistics You can display CPU utilization statistics for RIP and other IP protocols. To display CPU utilization statistics for RIP for the previous five-second, one-minute, five-minute, fifteen-minute, and runtime intervals, enter the following command at any level of the CLI. 918 PowerConnect B-Series FCX Configuration Guide 53-1002266-01