Dell PowerConnect FCS624S Configuration Guide - Page 991

Configuring OSPF 29 NOTE Redistribution is permitted for all routes by default, so the permit redistribute 1 all command in the example above is shown for clarity but is not required. You also have the option of specifying import of just OSPF, BGP4, or static routes, as well as specifying that only routes for a specific network or with a specific cost (metric) be imported, as shown in the following command syntax. Syntax: deny | permit redistribute all | bgp | connected | rip | static [address [match-metric [set-metric ]]] Example To redistribute RIP, static, and BGP4 routes into OSPF, enter the following commands on the Layer 3 Switch acting as an ASBR. PowerConnectASBR(config)#router ospf PowerConnectASBR(config-ospf-router)#permit redistribute 1 all PowerConnectASBR(config-ospf-router)#write memory Syntax: deny | permit redistribute all | bgp | connected | rip | static address [match-metric | set-metric ] NOTE Redistribution is permitted for all routes by default, so the permit redistribute 1 all command in the example above is shown for clarity but is not required. You also have the option of specifying import of just OSPF, BGP4, or static routes, as well as specifying that only routes for a specific network or with a specific cost (metric) be imported, as shown in the following command syntax. For example, to enable redistribution of RIP and static IP routes into OSPF, enter the following commands. PowerConnect(config)#router ospf PowerConnect(config-ospf-router)#redistribution rip PowerConnect(config-ospf-router)#redistribution static PowerConnect(config-ospf-router)#write memory Syntax: [no] redistribution bgp | connected | rip | static [route-map ] NOTE The redistribution command does not perform the same function as the permit redistribute and deny redistribute commands. The redistribute commands allow you to control redistribution of routes by filtering on the IP address and network mask of a route. The redistribution commands enable redistribution for routes of specific types (static, directly connected, and so on). Configure all your redistribution filters before enabling redistribution. NOTE Do not enable redistribution until you have configured the redistribution filters. If you enable redistribution before you configure the redistribution filters, the filters will not take affect and all routes will be distributed. PowerConnect B-Series FCX Configuration Guide 949 53-1002266-01