Dell PowerConnect FCS624S Configuration Guide - Page 1141

Clearing diagnostic buffers 30 • The first 400 bytes of the last packet that contained an error • The last NOTIFICATION message either sent or received by the Layer 3 Switch To display these buffers, use options with the show ip bgp neighbors command. Refer to "Displaying BGP4 neighbor information" on page 1067. This information can be useful if you are working with Dell Technical Support to resolve a problem. The buffers do not identify the system time when the data was written to the buffer. If you want to ensure that diagnostic data in a buffer is recent, you can clear the buffers. You can clear the buffers for a specific neighbor or for all neighbors. If you clear the buffer containing the first 400 bytes of the last packet that contained errors, all the bytes are changed to zeros. The Last Connection Reset Reason field of the BGP neighbor table also is cleared. If you clear the buffer containing the last NOTIFICATION message sent or received, the buffer contains no data. You can clear the buffers for all neighbors, for an individual neighbor, or for all the neighbors within a specific peer group. To clear these buffers for neighbor 10.0.0.1, enter the following commands. PowerConnect#clear ip bgp neighbor 10.0.0.1 last-packet-with-error PowerConnect#clear ip bgp neighbor 10.0.0.1 notification-errors Syntax: clear ip bgp neighbor all | | | last-packet-with-error | notification-errors The all | | | option specifies the neighbor. The parameter specifies a neighbor by its IP interface with the Layer 3 Switch. The specifies all neighbors in a specific peer group. The parameter specifies all neighbors within the specified AS. The all parameter specifies all neighbors. PowerConnect B-Series FCX Configuration Guide 53-1002266-01 1099