Dell PowerConnect FCS624S Configuration Guide - Page 149

Building an IronStack 5 PowerConnect# show running config Current configuration: ! ver 07.2.00a ! stack unit 1 module 1 FCX-24-port-management-module priority 255 stack unit 2 module 1 FCX-24-port-management-module priority 240 stack unit 3 module 1 FCX-24-port-management-module stack enable ! NOTE For field descriptions for the show running config command, refer to "Displaying running configuration information" on page 143. 10. To see information about your stack, enter the show stack command. PowerConnect# show stack alone: standalone, D: dynamic config, S: static config ID Type Role Mac Address Pri State Comment 1 S FCX624 active 00e0.5200.0100 255 local Ready 2 S FCX624 standby 0012.f2eb.afc0 240 remote Ready 3 S FCX624 member 001b.ed5d.a1c0 0 remote Ready active standby +---+ +---+ +---+ -2/1| 1 |3/1--2/1| 2 |3/1--2/2| 3 |2/1- | +---+ +---+ +---+ | | | Current stack management MAC is 00e0.5200.0100 PowerConnect# NOTE For field descriptions for the show stack command, refer to "Displaying stack information" on page 135. Configuration notes for scenario 2 Consider the following items when building a stack using the automatic setup process: • If a new unit configuration matches other unit configurations, the Active Controller gives this unit the lowest sequential ID. • In a ring topology, the same new unit might assume either ID if either direction produces sequential IDs. For example, in a four-member stack where IDs 2 and 4 are reserved, a new unit could assume either I2 or ID 4 because either ID 1,2,3 or 1, 3, 4 is sequential. PowerConnect B-Series FCX Configuration Guide 107 53-1002266-01