Dell PowerConnect FCS624S Configuration Guide - Page 347

Chapter Configuring Basic Layer 2 Features 9 Table 57 lists the individual Dell PowerConnect switches and the basic Layer 2 features they support. TABLE 57 Feature Supported basic Layer 2 features PowerConnect B-Series FCX 16,000 MAC addresses per switch Yes 32,000 MAC addresses per switch Yes MAC learning rate control Yes Multi-port static MAC address Yes Static MAC entries with option to set Yes traffic priority Flow-based MAC address learning Yes Enabled by default on PowerConnect B-Series FCX devices. There is no CLI command to enable or disable it. Port-based VLANs Yes Address locking (for MAC addresses) Yes MAC address filter override of 802.1X Yes MAC address filtering (filtering on source Yes and destination MAC addresses) Ability to disable MAC learning Yes Dynamic buffer allocation for QoS Yes priorities Remote Fault Notificatoin (RFN) for 1G Yes fiber Link Fault Signaling (LFS) for 10G Yes Layer 2 jumbo frames Yes Generic buffer profile Yes The procedures in this chapter describe how to configure basic Layer 2 parameters. Dell PowerConnect devices are configured at the factory with default parameters that allow you to begin using the basic features of the system immediately. However, many of the advanced features such as VLANs or routing protocols for the device must first be enabled at the system (global) level before they can be configured. If you use the Command Line Interface (CLI) to configure system parameters, you can find these system level parameters at the Global CONFIG level of the CLI. NOTES: • Before assigning or modifying any router parameters, you must assign the IP subnet (interface) addresses for each port. PowerConnect B-Series FCX Configuration Guide 305 53-1002266-01