Dell PowerConnect FCS624S Configuration Guide - Page 995

Configuring OSPF 29 Because this ACL is input to an OSPF distribution list, the parameter actually specifies the subnet mask of the route. The parameter specifies the portion of the subnet mask to match against. For example, the and values 255.255.255.255 0.0.0.255 mean that subnet mask /24 and longer match the ACL. If you want the policy to match on all network masks, enter any any. Modifying the default metric for redistribution The default metric is a global parameter that specifies the cost applied to all OSPF routes by default. The default value is 10. You can assign a cost from 1 through 15. NOTE You also can define the cost on individual interfaces. The interface cost overrides the default cost. To assign a default metric of 4 to all routes imported into OSPF, enter the following commands. PowerConnect(config)#router ospf PowerConnect(config-ospf-router)#default-metric 4 Syntax: default-metric The can be from 1 through 16,777,215. The default is 10. Enabling route redistribution To enable route redistribution, use one of the following methods. NOTE Do not enable redistribution until you have configured the redistribution filters. Otherwise, you might accidentally overload the network with routes you did not intend to redistribute. To enable redistribution of RIP and static IP routes into OSPF, enter the following commands. PowerConnect(config)#router ospf PowerConnect(config-ospf-router)#redistribution rip PowerConnect(config-ospf-router)#redistribution static PowerConnect(config-ospf-router)#write memory Example using a route map To configure a route map and use it for redistribution of routes into OSPF, enter commands such as the following. PowerConnect B-Series FCX Configuration Guide 953 53-1002266-01