Dell PowerEdge 1655MC Information and Firmware Update - Page 15
Replacing the Server Module Battery
View all Dell PowerEdge 1655MC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3 Type 0 (zero) for image update. 4 Change the remote system's baud rate to 115200 (see "Setting Up the Remote System Serial Connection Baud Rate"). 5 Click Send to access the Send File dialog box. 6 Select Xmodem protocol. 7 Browse and select the file runtimexxx.bix, where xxx is the version of the runtime component. 8 Click Send to download the file. The download takes approximately 5 minutes. 9 After the download is complete, press to update the runtime component. 10 Type runtime for the filename. 11 After the update is complete, change the remote system's baud rate to 9600 (see "Setting Up the Remote System Serial Connection Baud Rate"). 12 To update other components, press any key to continue, and proceed to "Updating the Diagnostics Component" or "Updating the Loader Component." If you are not updating any other components, remove the network switch module and move the jumper back to pins 1 and 2 (default). NOTE: If you do not move the jumper back to pins 1 and 2, you will not be able to use ERA/MC console redirection to log into the network switch module. Replacing the Server Module Battery CAUTION: Only trained service technicians are authorized to remove and access any components inside the system. See your System Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. Information and Firmware Update 1-11