Dell PowerEdge M620 Owners Manual - Page 51
Configuring The Boot Drive, Removing A Hard Drive/SSD From A Hard-Drive/SSD Carrier
View all Dell PowerEdge M620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
CAUTION: If you need to power off the blade to service a hard drive/SSD, wait 30 seconds after the blade's power indicator turns off before removing the hard drive/SSD. Otherwise, the hard drive/SSD may not be recognized after it is reinstalled and the blade is powered on again. Configuring The Boot Drive The drive or device from which the system boots is determined by the boot order specified in the System Setup. Removing A Hard Drive/SSD From A Hard-Drive/SSD Carrier 1. Remove the four screws from the slide rails on the hard-drive/SSD carrier. 2. Lift the hard drive/SSD out of the hard-drive/SSD carrier. Figure 18. Removing and Installing a Hard Drive/SSD in a Hard-Drive/SSD Carrier 1. hard drive/SSD 2. screw holes (4) 3. hard-drive/SSD carrier 4. screws (4) Installing A Hard Drive/SSD In A Hard-Drive/SSD Carrier 1. Insert the hard drive/SSD into the hard-drive/SSD carrier with the drive's controller board's connector end of the drive at the back of the carrier. 2. From the back of the carrier, slide the drive into the carrier. 3. Align the screw holes on the hard drive/SSD with the holes on the hard-drive/SSD carrier. CAUTION: To avoid damaging the drive or the carrier, do not overtighten the screws. 4. Attach the four screws to secure the hard drive/SSD to the hard-drive/SSD carrier. 51