Dewalt DXGNR5700 Instruction Manual - Page 16

Operation B 7000 Canada 003606 A 5. Slide engine choke (C) to Full Choke position (left). 000208 C 4. Turn engine Run/Stop switch (B) to Run (manual start only). B 5700 - 50 State B 5700 - Canada B 7000 - 50 State 12 003286 003287 000787 000209 6. Firmly grasp recoil handle and pull slowly until increased resistance is felt. Pull rapidly up and away. 7. When engine starts, move choke knob to 1/2-choke position until engine runs smoothly, then fully into Run position. If engine falters, move choke back to 1/2-choke position until engine runs smoothly, then to Run position. 8. If engine fires, but does not continue to run, move choke lever to Full Choke and repeat starting instructions. IMPORTANT: Do not overload the generator. Also, do not overload individual panel receptacles. These outlets are protected against overload with push-to-reset type circuit breakers. If amperage rating of any circuit breaker is exceeded, that breaker opens and electrical output to that receptacle is lost. Read "Don't Overload the Generator" carefully. Starting Electric Start Engines CAUTION Equipment and property damage. Disconnect electrical loads prior to start- ing or stopping unit. Failure to do so could result in equipment and property damage. 1. Unplug all electrical loads from the unit's receptacles before starting the engine. 2. Place generator on a level surface. 3. Open the fuel shut-off valve. 4. Move engine choke knob outward to Full Choke. 5. Press and hold Start/Run/Stop switch in the Start position. When engine starts, release the switch to the Run position. 6. When engine starts, move choke knob to 1/2 choke position until engine runs smoothly, then fully to RUN position. If engine falters, move choke knob back to 1/2 choke position until engine runs smoothly, then move to Run position. Owner's Manual for Portable Generator