Epson ActionNote 910C User Manual - Page 51

Customizing Computer Settings, The current configuration is probably fine

Get Epson ActionNote 910C PDF manuals and user guides View all Epson ActionNote 910C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 51 highlights

To select a setting click the button for that setting, then adjust the controls. When you've made changes, click OK to exit. Your settings take effect immediately. NOTE If you install another pointing device and then want to return to the ActionPoint, you need to reinstall the ActionPoint drivers. Type the following commands at the MS-DOS prompt: CD\SYNTOUCH INSTALL Customizing Computer Settings Setup configures your ActionNote and stores the settings in the computer's CMOS ROM (read-only memory). Because this area of memory is backed up by a battery, it is not erased when you turn off or reset the computer. The current configuration is probably fine for most of your needs. However, you may need to run Setup when you upgrade your computer or connect new equipment. You can also run Setup to customize power management. Customizing Your Computer 6-3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
To select a setting click the button for that
setting, then adjust the controls.
When you’ve made changes, click
OK
to exit.
Your settings take effect immediately.
NOTE
If you install another pointing device and
then want
to return to the ActionPoint, you need to reinstall
the ActionPoint drivers. Type the following
commands at the MS-DOS prompt:
CD\SYNTOUCH
INSTALL
Customizing Computer Settings
Setup configures your ActionNote and stores
the settings in the computer’s CMOS ROM
(read-only memory). Because this area of
memory is backed up by a battery, it is not
erased when you turn off or reset the computer.
The current configuration is probably fine for
most of your needs. However, you may need to
run Setup when you upgrade your computer
or connect new equipment. You can also run
Setup to customize power management.
Customizing
Your Computer
6-3