Epson ActionTower 8100 User Manual - Page 107
Installing a Drive in an External Drive Bay
![]() |
View all Epson ActionTower 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
3. Remove the screws securing the hard disk drive to the bracket and slide the drive out of the bracket. 4. If you removed the only IDE device connected to the interface the device used, you may want to disconnect the device cable from its interface on the system board and remove it from the computer. 5. Replace the bracket following the instructions under "Replacing the Bracket in the Computer." 6. If you have finished installing or removing drives, replace the computer's cover; see "Replacing the Cover" in Chapter 4 for instructions. Then see "Running SETUP" in Chapter 2 for instructions on defining your new drive configuration. Installing a Drive in an External Drive Bay Your system includes two externally accessible drive bays. Using these bays, you can install any type of drive, including internal hard disk drives. If you are installing a hard disk drive or another IDE device, be sure its jumper(s) are set correctly for your configuration; see "Setting the IDE Device Jumpers and Locating Pin 1" in Chapters 5 and 6 for instructions. Before you can install a drive in one of the external bays, you must remove the mounting bracket containing the diskette drive (and possibly a hard disk drive). Follow the instructions under "Removing the Drive Mounting Bracket." (You can remove the bracket and drives without disconnecting the drive cables.) Installing and Removing Drives in the Slimline Computer 5-13
![](/manual_guide/products/epson-actiontower-8000-user-manual-716f320/107.png)