Epson ActionTower 8100 User Manual - Page 36
Defining your own drive parameters, Transfer mode, Fast Pl0l, Fast, LBA Mode Control, Enabled.
View all Epson ActionTower 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
The Transfer mode option selects the method for transferring data between the hard disk and system memory. If this option is not automatically set, you can select Standard (thedefault), Fast Pl0l, Fast P102,or Fast P103. The LBA Mode Control option enables or disables ISA logical block address (LBA) mode control for each drive. If this option is not detected automatically, and your drive supports LBA mode control, select Enabled. Many drives larger than 528MB support LBA mode control, but some older drives do not; check the drive documentation. The 32 Bit I/O option sets the I/O transfer rate for data read from the disk. If your drive supports 32-bit I/O transfers, select Enabled; the default setting is Disabled (16-bit transfers). Defining your own drive parameters If the parameters for your hard disk do not match the parameters detected by the auto-sensing feature, you must define your own drive parameters. Follow these steps: 1. Move the cursor to Type and select User. 2. Type the values in each field that are appropriate for your hard disk drive. 3. When you leave SETUP, make sure you save your changes. Running SETUP and Installing Drivers 2-7