Epson ActionTower 8100 User Manual - Page 96
Setting the IDE Device Jumpers and Locating Pin 1
![]() |
View all Epson ActionTower 8100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Some of the steps in this chapter may not apply for the drive you are installing. See the documentation that came with your drive for more information. Your computer can hold up to four mass storage devices, including the diskette drive (and possibly other drives) that came with your system. You can replace the existing hard disk drive in the internal mounting bracket. In the externally accessible bays, you can install a CD-ROM drive or another type of drive. To install or remove a drive, first remove the computer's cover as described under "Removing the Cover" in Chapter 4. Then remove any option cards that may be in your way. Once you have installed the drive, replace any option cards you removed. See "Installing an Option Card" in Chapter 4 for instructions. Setting the IDE Device Jumpers and Locating Pin 1 Before you install any IDE devices, be sure to check the device's jumper settings. The jumpers indicate the master and slave configuration of devices connected to both of the IDE interfaces. A table in the "Hard Disk Drive Information" section of the Appendix lists the master and slave jumper settings for the IDE hard disk drives that are qualified for use in your computer. If your drive is not listed or you need more information, see the documentation that came with your drive or contact the manufacturer. If you are installing another type of IDE device, such as an IDE CD-ROM drive, check the documentation that came with the device for the master and slave jumper settings. 5-2 Installing and Removing Drives in the Slimline Computer
![](/manual_guide/products/epson-actiontower-8000-user-manual-716f320/96.png)