Epson ActionTower 8400 User Manual - Page 131
Installing a Drive in the Rear Internal Bracket
![]() |
View all Epson ActionTower 8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
4. If you removed the only IDE device connected to the interface the device used, you may want to disconnect the device cable from the interface on the system board and remove it from the computer. 5. If you have finished installing or removing drives, replace the computer's cover; see "Replacing the Cover" in Chapter 4 for instructions. Then see "Running SETUP" in Chapter 2 for instructions on defining your new drive configuration. Installing a Drive in the Rear Internal Bracket Your computer has a hard disk drive installed in the rear internal drive bracket. Follow these steps to install a second drive in this drive bay: 1. Remove the drive and power cables from the back of the drive already installed in the rear internal drive bracket. 2. Remove the four screws securing the rear internal drive bracket to the computer's back panel and slide it out of the computer. Make sure you save the screws. 6-16 Installing and Removing Drives in the Tower Computer
![](/manual_guide/products/epson-actiontower-8000-user-manual-716f320/131.png)