Epson ActionTower 8400 User Manual - Page 141
The power cord is securely connected, but the computer, still does not start.
![]() |
View all Epson ActionTower 8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
Caution If you turn off the computer, always wait at least 20 seconds before turning it back on to prevent damage to its circuitry. If your computer is set to boot from drive C, make sure that the IDE hard drive is formatted. Also make sure that the primary IDE controller is enabled by checking the setting of jumper JP13 on the system board; see "Changing the Jumper Settings" in Chapter 4. The computer does not start and the power light is not lit. Make sure the power cord is securely connected to both the AC inlet on the back panel and an electrical outlet. The power cord is securely connected, but the computer still does not start. Check the electrical outlet for power. Turn off your computer and unplug the power cord. Plug a lamp into the outlet and turn it on. You installed or removed system components, and now your computer does not start. Check to make sure you have reconnected all the internal and external cables correctly. You may have installed a SIMM incorrectly. If the system doesn't detect memory, it won't start. Check that your SIMMs are securely installed in the correct sockets. 7-4 Traubleshooting
![](/manual_guide/products/epson-actiontower-8000-user-manual-716f320/141.png)