Epson ActionTower 8400 User Manual - Page 83
Installing a Card in the Slimline Computer (2-slot Side)
View all Epson ActionTower 8400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
5. Replace the computer's cover; see "Replacing the Cover." Then see "Post-installation Procedures" for instructions on configuring your computer with your new option card. Installing a Card in the Slimline Computer (2-slot Side) The option card connector board in the slimline computer has two slots on one side and three slots on the other. Although the illustration shows an ISA card, you can use the same instructions to install a PCI card. Follow these steps to install an option card on the two-slot side: 1. Remove the retaining screw securing the slot cover bracket. Remove the bracket by lifting it straight up and out of the small metal holder that secures it. 2. Remove the slot cover for the slot you are going to use. 3. Hold the card by the top corners and guide it into the slot. Then push the card in firmly (but carefully); you should f&l it fit into place. If it does not go in smoothly, do not force it; pull the card out and try again. Installing and Removing Options 4-19