Home » Fluke Manuals » Electronics Accessories » Fluke 719PRO-300G » Manual Viewer

Fluke 719PRO-300G Product Manual - Page 56

Command, Description

Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

719PRO Users Manual Command DAMP DAMP? DISPLAY DISPLAY? ERROR_LOOP ERROR_LOOP? ERROR_MODE ERROR_MODE? ERROR_PORT ERROR_PORT? Description Turns Damp on or off. Returns if DAMP is on/off Turns on/off the displays specified in the command Returns which displays are on/off Turns loop power on or off in percent error mode Returns the current state of loop power in error mode Turns percent error mode on or off Returns whether percent error mode is on or off Set the pressure port for percent error mode Returns the pressure port for percent error mode 46 Command FAULT? FUNC FUNC? HART_ON HART_OFF HART? HI_ERR HI_ERR? IO_STATE IO_STATE? Description Returns the most recent error code Sets the display mode as specified in the command Returns the current mode of the upper, middle, and lower display Turns the hart resistor on. Turns the hart resistor off. Returns the current state of the Hart resistor. Sets the 100 % of span limit for percent error mode Returns the 100 % of span limit for percent error mode Set the Product's mA state. Return the Product's mA state. MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664

Section	Page
719PRO Users Manual	1
Warranty	2
Table of Contents	3
List of Tables	7
List of Figures	9
Introduction	11
Contact Fluke	11
Safety Information	12
Symbols	14
Standard Equipment	15
Product Features	15
Display	18
Language Selection	19
Home Menu Functionality	20
Backlight Use	20
The MENU Option	20
Main Menu Functionality	21
Set the Active Display	21
Set Active Display Parameters	21
Zero Function Use	23
Internal Sensor and Pressure Module (non-absolute)	23
Absolute Pressure	23
Other Menu Controlled Functions	24
Set the Contrast	24
Lock and Unlock Configurations	25
Save and Recall Setups	25
Set Auto Off Parameters	26
Activate and Deactivate a Display	27
Set the RTD Probe Type	27
Damping	28
HARTTM Resistor	28
Pump Limits	28
Initial Setup and Basic Pressure Generation	28
Electric Pump Considerations	30
Measure Pressure	30
Media Compatibility	31
Measure Pressure with External Modules	31
Measure and Generate Current (4 mA to 20 mA)	32
Measure Voltage	34
Measure Temperature with an RTD	35
Pressure Switch Test	36
Transmitter Calibration	39
mA Input Function	39
Pressure-to-Current Transmitter Calibration	40
Percent Error Function	40
Minimum and Maximum Storage Capability	45
Factory Setups	46
Custody Transfer / Flow Calibration	49
Remote Operation	49
Remote Interface	49
Set up the RS-232 Port for Remote Control	51
Change Between Remote and Local Operation	52
Command Use and Types	52
Character Processing	53
Response Data Types	54
Calibrator Status	54
Remote Commands and Error Codes	55
Enter Commands	60
Common Commands	60
Calibrator Commands	61
Ranges and Resolution	69
Maintenance	71
Replace the Batteries	71
Clean the Product	73
Clean the Valve Assembly	73
User-Replaceable Parts and Accessories	74