Foxconn FlamingBlade GTI English Manual. - Page 14

CAUTION 1 ! ■ Make sure the power supply is turned off before pressing the CLR_CMOS button to clear CMOS. ■ Push down the CLR_CMOS button and hold it there for a couple of seconds to clear the CMOS completely, then release. 4. Optical S/PDIF Out Connector This connector provides digital audio out to an external audio system that supports digital optical audio. 5. External SATA Port (Only for Flaming Blade) To connect external SATA device(s) to your system by expanding the internal SATA port(s) to the chassis back panel. External SATA device shall provide power by its own. 6. Audio Ports For the definition of each audio port, please refer to the table below : Port Blue Green Pink Orange Black Grey 2-channel Line In Line Out Microphone In - 4-channel Line In Front Speaker Out Microphone In - Rear Speaker Out - 5.1-channel Line In Front Speaker Out Microphone In Center/Subwoofer Out Rear Speaker Out - 7.1-channel Line In Front Speaker Out Microphone In Center/Subwoofer Out Rear Speaker Out Side Speaker Out 7. RJ-45 LAN Port Each Gigabit Ethernet LAN port provides Internet connection at up to 1Gb/s data rate. Both Gigabit Ethernet LAN ports can be combined in teming mode to support connection speeds up to 2Gb/s! LAN Type 1000M Left: Active Status Description Off No Link Green Blinking Data Activity Status Off Off Green Orange Right: Link Description No Link 10 Mb/s Connection 100 Mb/s Connection 1000 Mb/s Connection Active Link LED LED