Foxconn FlamingBlade GTI English Manual. - Page 24

2 Front Panel Connector : FP1 This motherboard includes one connector for connecting the front panel switch and LED Indicators. Hard Disk LED Connector (HDD-LED) Connect to the chassis front panel IDE indicator LED. It indicates the active status of the hard disks. This 2-pin connector is directional with +/- sign. Reset Switch (RESET-SW) Attach the connector to the Reset switch on the front panel of the case; the system will restart when the switch is pressed. Power LED Connector (PWR-LED) Connect to the power LED indicator on the front panel of the chassis. The Power LED indicates the system's status. When the system is in operation (S0 status), the LED is on. When the system gets into sleep mode (S1) , the LED is blinking; When the system is in S3/S4 sleep state or power off mode (S5), the LED is off. This 2-pin connector is directional with +/- sign. Power Switch Connector (PWR-SW) Connect to the power button on the front panel of the chassis. Push this switch allows the system to be turned on and off rather than using the power supply button. 12 + + HDD-LED - PWR-LED - RESET-SW PWR-SW NC EMPTY 9 10 FP1 Audio Connector : CD_IN CD_IN is a Sony standard audio connector, it can be connected CD_L GND CD_R to a CD/DVD-ROM drive through a CD/DVD audio cable. 1 CD_IN Speaker Connector : SPEAKER The speaker connector is used to connect speaker of the chassis. SPKJ 1 EMPTY 2 NC 3 SPKJ 4 SPEAKER Serial ATA Connectors : SATA_1/2/3/4/5/6 The Serial ATA connector is used to connect with SATA Hard 1 GND TX+ Disk or CD devices which support this feature. The current Se- TXGND rial ATA II interface allows up to 300MB/s data transfer rate. RXRX+ GND SATA_1/2/3/4/5/6 17