HP 3600dn HP Jetdirect Print Server Administrator's Guide - Page 45
TCP/IP Diagnostics, Keep DHCP settings only. Once the Fully Qualified Domain Name is con d
UPC - 829160888897
View all HP 3600dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Table 3-3 Telnet Commands and Parameters (continued) 1: Keep DHCP settings only. Once the Fully Qualified Domain Name is configured through DHCP, manual changes cannot be made. 2: Keep manual settings. The settings can be manually configured. DHCP may be used only if the settings are factory-default values. 3: Keep manual settings only. While manual configuration methods may be used, configuration through DHCP is not allowed. dhcp-arbitration Specifies the amount of time, in seconds, that the print server will wait for DHCP configuration offers. A value from 1 to 10 may be set. The default is 5 seconds. phone-home-config TCP/IP Diagnostics Last Config IP TCP Conns Refused TCP Access Denied DHCP Lease Time DHCP Renew Time DHCP Rebind Time Specifies privacy settings on the print server during embedded Web server access. This command controls whether statistical data on product use may be sent to HP. For HP to collect data, Internet access is required. 2: Prompt the user to allow sending data on initial access to the Networking tab of the embedded Web server. This is the factory-default and cold-reset value. Once changed, this value cannot be re-selected. 1: Allows the sending of data to HP without prompting the user. 0: Disables sending data to HP without prompting the user. (Read-only parameter) The IP address of the system from which the HP Jetdirect print server's IP address was configured. (Read-only parameter) The number of client TCP connections that are refused by the print server. (Read-only parameter) The number of times that client systems were denied access to the print server because there was no allowable entry in the print server's host access list. (Read-only parameter) DHCP IP address lease duration time (seconds). (Read-only parameter) DHCP T1 timeout, specifying the DHCP lease renewal time (seconds). (Read-only parameter) DHCP T2 timeout, specifying the DHCP lease rebind time (seconds). SNMP snmp-config Enables or disables SNMP operation on the print server. 0 disables, 1 (default) enables SNMP. CAUTION Disabling SNMP will disable all SNMP agents (SNMP v1, v2c) as well as communications with management applications, such as HP Web Jetadmin. In addition, firmware upgrades through current HP downloading utilities will be disabled. get-cmnty-name set-cmnty-name Specifies a password that determines which SNMP GetRequests the HP Jetdirect print server will respond to. This is optional. If a user-specified get community name is set, the print server will respond to either a user-specified community name or the factorydefault. The community name must be ASCII characters. The maximum length is 255 characters. Specifies a password that determines which SNMP SetRequests (control functions) the HP Jetdirect print server will respond to. The community name of an incoming SNMP ENWW Using Telnet 37