HP 3600dn HP Jetdirect Print Server Administrator's Guide - Page 59

Table 4-3 SNMP Settings (continued) Item Description The default Get community name is "public", which can be disabled to restrict access by checking the checkbox provided. NOTE If "public" is disabled, some port monitors or discovery utilities may not operate properly. Enable SNMPv1/v2 read-only access Disable SNMPv1/v2 This option enables the SNMP v1/v2c agents on the print server, but limits access to read-only. Write-access is disabled. The default Get community name "public" is automatically enabled. This option disables the SNMP v1/v2c agents on the print server, which is recommended for secure environments. If SNMP v1/v2c is disabled, some port monitors or discovery utilities may not operate properly. Other Settings This item provides access to a variety of management and printing configuration options. The following tabs are provided: ■ Misc. Settings: for enabling miscellaneous advanced protocols and functions ■ LPD Queues: for setting up print queues used in printing under LPD (line printer daemon) printing services ■ Support Info: to set up the Support link located under Other Links in the left margin ■ Refresh Rate: to set the time interval (in seconds) for embedded Web diagnostic page updates Misc. Settings The Miscellaneous Settings parameters allow you to set a variety of advanced protocols and features, as described below. See Table 4-4 Miscellaneous Settings. Table 4-4 Miscellaneous Settings Item SLP Config Telnet Config mDNS Multicast IPv4 Description Enable or disable SLP (Service Location Protocol), used by selected client application software to automatically discover and identify the HP Jetdirect print server. Enable or disable access to HP Jetdirect configuration parameters using Telnet. For more information, see TCP/IP Configuration. Enable or disable Multicast Domain Name System (mDNS) services. mDNS is typically used on small networks for IP address and name resolution (through UDP port 5353) where a conventional DNS server is not used. For mDNS operation, Multicast IPv4 must be enabled. Enable or disable the receipt and transmission of IP version 4 multicast packets by the print server. If this parameter is disabled, other protocols that use multicast protocols, such as mDNS and SLP, may also be disabled without notification. NOTE If this parameter is disabled, other protocols that use multicast protocols, such as mDNS and SLP, may also be disabled without notification. ENWW Networking Tab 51