HP 3600dn HP Jetdirect Print Server Administrator's Guide - Page 60
Using the Embedded Web Server, Table 4-4
UPC - 829160888897
View all HP 3600dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Table 4-4 Miscellaneous Settings (continued) Item Description 9100 Printing Enable or disable port 9100 services. Port 9100 is an HP-proprietary raw TCP/IP port on the HP Jetdirect print server and is the default port for printing. It is accessed by HP software (for example, the HP Standard Port Monitor). LPD Printing Enable or disable the Line Printer Daemon services on the HP Jetdirect print server. LPD on the HP Jetdirect print server provides line printer spooling services for TCP/IP systems. For more information, see Configuring for LPD Printing. Link settings Set the network link speed(10 or 100 Mbps) and communication mode (full- or halfduplex) for HP Jetdirect 10/100TX print servers. The available settings are listed below. CAUTION If you change the link setting, network communications with the print server and network device may be lost. ■ AUTO: (Default) The print server uses auto-negotiation to match the network's link speed and communication mode. If auto-negotiation fails, either 100TX HALF or 10T HALF is set depending on the detected link speed of the hub/switch port. ■ 10T FULL: 10 Mbps, full-duplex operation ■ 10T HALF: 10 Mbps, half-duplex operation ■ 100TX FULL: 100 Mbps, full-duplex operation ■ 100TX HALF: 100 Mbps, half-duplex operation Primary DNS Server Secondary DNS Server Syslog Facility Dynamic Raw Port Setting mDNS Service Name mDNS Domain Name mDNS Highest Priority Service Specify the IP address of the primary DNS (Domain Name System) server. Specify the IP address of a secondary DNS server to use if the primary DNS server is unavailable. Specify the encoded source facility of a message (for example, to identify the source of selected messages during troubleshooting). By default, the HP Jetdirect print server uses LPR as the source facility code, but local user values of local0 through local7 can be used to isolate individual or groups of print servers. Allows additional ports to be specified for printing to TCP port 9100. Valid ports are 3000 to 9000, which are application-dependent. Specifies an alphanumeric string of up to 64 ASCII characters assigned to this device or service. This name is persistent and is used to resolve a particular device or service if socket information (such as the IP address) changes from session to session. Apple Rendezvous will display this service. The default service name is the printer model and the last six digits of the LAN Hardware (MAC) address. (Read-only parameter) Specifies the mDNS domain name assigned to the device, in the form .local. If a user-specified host name has not been assigned, the default host name NPIxxxxxx is used, where xxxxxx are the last 6 digits of the LAN hardware (MAC) address. Specifies the mDNS highest priority service to use for printing.To set this parameter, choose one of the following printing options: 9100 Printing: Raw IP printing through HP-proprietary port 9100. IPP Printing: Internet Printing Protocol printing. LPD Printing (RAW): Default LPD raw queue printing. LPD Printing (TEXT): Default LPD text queue printing. 52 Chapter 4 Using the Embedded Web Server ENWW