HP 3600dn HP Jetdirect Print Server Administrator's Guide - Page 86
HP Jetdirect Configuration TCP/IP Configuration Information continued
UPC - 829160888897
View all HP 3600dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Table 7-4 TCP/IP Configuration Information (continued) Message Description 169.254/16 or 192.0.0.192 is assigned if a valid IP address cannot be obtained over the network after 2 minutes. NOT SPECIFIED: Indicates that an IP address is not assigned or the value is zero. SUBNET MASK: The IP subnet mask configured on the HP Jetdirect print server. During initialization, a temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the print server may automatically assign a usable default value. NOT SPECIFIED: Indicates that a subnet mask is not configured. DEFAULT GATEWAY: The IP address of the gateway used when sending packets off the local network. Only one default gateway may be configured. During initialization, a temporary value 0.0.0.0 is displayed. If not provided, the IP address of the Jetdirect print server is used. NOT SPECIFIED: Indicates that a default gateway is not configured. CONFIG BY: Identifies how the HP Jetdirect print server obtained its IP configuration: BOOTP: Automatic configuration through a BOOTP server. BOOTP/TFTP: Automatic configuration through a BOOTP server and TFTP configuration file. DHCP: Automatic configuration through a DHCP server DHCP/TFTP: Automatic configuration through a DHCP server and TFTP configuration file. RARP: Automatic configuration through the Reverse Address Resolution Protocol. USER SPECIFIED: Manual configuration through Telnet, the printer's control panel, HP Web Jetadmin, embedded Web server, or other method. DEFAULT IP: The default IP address was assigned. This address may not be a valid address for your network. AUTO IP: A link-local IP address (169.254.x.x) was assigned. If the network is a linklocal network, this address should be valid. NOT CONFIGURED: The print server was not configured with IP parameters. Verify that TCP/IP is enabled, or check for error status. BOOTP SERVER: or DHCP SERVER: or RARP SERVER: Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It specifies the IP address of the system that responds to the HP Jetdirect print server's request for automatic TCP/IP configuration over the network. NOT SPECIFIED: Indicates that the configuration server's IP address could not be determined or was set to zero in the response packet. BOOTP/DHCP SERVER: Displayed during initialization while the HP Jetdirect print server attempts to obtain its TCP/IP configuration from a BOOTP or DHCP server. The temporary address displayed is 0.0.0.0. TFTP SERVER: The IP address of the system where the TFTP configuration file is located. During initialization, the temporary address 0.0.0.0 is displayed. NOT SPECIFIED: Indicates that a TFTP server has not been not been set. CONFIG FILE: The name of the HP Jetdirect configuration file. The file pathname may be truncated to fit on two lines. NOT SPECIFIED: Indicates that a file was not specified in the BOOTP reply from the host. 78 Chapter 7 HP Jetdirect Configuration Page ENWW