HP 3600dn HP Jetdirect Print Server Administrator's Guide - Page 74
Disabling the Embedded LAN, Restore Factory Settings, Select, Ready, Attention, Select Language
UPC - 829160888897
View all HP 3600dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
NOTE The Restore Factory Settings menu item in the printer control panel menu will not reset the HP Jetdirect print server. After resetting to factory default values, print a Jetdirect configuration page to confirm that factory-reset values have been assigned. To perform a cold reset: 1 Turn the printer on and watch for the memory count to begin. 2 Press and hold the Select button until the three control panel lights (Ready, Data, Attention) blink and then remain on. 3 Release the Select button. The control panel will display Select Language. 4 Press the down arrow M button until Cold Reset appears. 5 Press the Select button to perform a cold reset and then continue its power-on sequence. Disabling the Embedded LAN For fault isolation to either printer or networking components, you can disable the Jetdirect embedded network interface. To disable the network components, follow these steps: 1 Turn the printer on and watch for the memory count to begin. 2 Press and hold the Select button until the three control panel lights (Ready, Data,Attention) blink and then remain on. 3 Release the Select button. The control panel will display Select Language. 4 Press the down arrow M button until Disable Embedded LAN appears. 5 Press the Select button. The embedded networking components will be disabled, and the printer will continue its power-on sequence. NOTE To enable the embedded network interface, use the same procedures, except choose Enable Embedded LAN in step 4 above. 66 Chapter 6 Troubleshooting the HP Jetdirect Print Server ENWW