HP 680n HP Wireless Print Server 680n - (English) Setup Guide - Page 22
Wait for the Print Server to Initialize, Print a Jetdirect Configuration
![]() |
UPC - 808736198622
View all HP 680n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Wait for the Print Server to Initialize When power is turned on, the print server may require up to two minutes before factory-default settings are assigned. After self-test, the wireless status LED should turn on or blink. (For wireless LED states, see "Troubleshooting".) Wireless LED Print a Jetdirect Configuration Page a. Use the printer control panel to print a Jetdirect configuration page. In most printers, a Jetdirect configuration page will print when you print a printer configuration page. Refer to your printer documentation for instructions to print a printer configuration page. b. See Figure 2-1. On the Jetdirect configuration page, check the print server settings. Since the print server is not yet configured or installed (until you complete the procedures in Chapter 3 and Chapter 4), many parameters will not reflect the operating values needed for your network. 2-2 Installing the Print Server Hardware
![](/manual_guide/products/hewlettpackard-680n-hp-wireless-print-server-680n-english-setup-guide-adbf8b6/22.png)