HP 8550 HP Color LaserJet 8550, 8550N, 8550DN, 8550GN, 8550MFP Printer - Getti - Page 14
Step 3: Installing the Cables - printer cable
View all HP 8550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Step 3: Installing the Cables To connect the power cord to a printer with a stand Note Make sure that the printer is off (power button out) before connecting the power cord. 1 Roll the printer to its permanent location, where all four wheels rest on a level floor surface, and stabilize it by pushing the locking tabs on the printer stand's wheels to the locked position. WARNING! An unstable printer can tip over and cause injury; make sure that the printer is secured properly. 2 Plug the female end of the power cord into the connector on the back left corner of the printer. 3 Plug the male end of the power cord into a surge protector or other grounded power source. 10 EN
10
EN
Step 3: Installing the Cables
To connect the power cord to a
printer with a stand
Note
Make sure that the printer is off (power
button out) before connecting the power
cord.
1
Roll the printer to its permanent
location, where all four wheels rest on
a level floor surface, and stabilize it by
pushing the locking tabs on the
printer stand's wheels to the locked
position.
WARNING!
An unstable printer can tip over and
cause injury; make sure that the printer
is secured properly.
2
Plug the female end of the power
cord into the connector on the back
left corner of the printer.
3
Plug the male end of the power cord
into a surge protector or other
grounded power source.