HP D2D .HP D2D Backup System user guide (EH985-90907, March 2011) - Page 95

Source Appliance Permissions tab Source Appliance Permissions are disabled by default. In this state, there is no control over mapping between share and library devices on the Target and the Source Appliances. However, if you want to lock down the ability to create share and library mappings so that, when the wizard is run and mappings are configured, the Target only has access to a list of sources that are allowed to replicate to it, click Edit and check the Enabled box. You will then need to create the list of source appliances and enable share and library permissions accordingly. To add a Source Appliance When you click Edit and check the Enabled box a list of source appliances is displayed. There is a wildcard entry in the Source Appliances list that allows you to set permissions across all source appliances. However, you are more likely to want to set permissions for individual appliances. Click Add. A wizard guides you through the necessary steps to add a new source appliance to the list. You will need to provide the serial number of the appliance and can also specify initial access permissions for all libraries and all shares on that appliance. Table 23 Source Appliances parameters Serial Number This is the serial number of the source appliance. This information can be found by running the Web Management Interface on the required appliance and looking at the Summary page. Backup System user guide 95