HP DL320 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide - Page 128
Installing an Expansion Board in Installing Hardware Options
UPC - 829160513218
View all HP DL320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
System Battery 3. Locate the battery holder on the system board. Refer to Figure 3-8 and Table 3-1 in Chapter 3, "Installing Hardware Options." 4. Remove the existing battery. Figure G-1: Removing the system battery 5. Install the new battery. 6. If you removed the PCI riser board assembly in step 3, reinstall it. Refer to "Installing an Expansion Board" in Chapter 3, "Installing Hardware Options." 7. Reverse the procedures performed in the "Accessing Internal Server Components" section in Chapter 3, "Installing Hardware Options." 8. Run the ROM-Based Setup Utility to reconfigure the system with the new battery. See Chapter 5, "Server Configuration and Utilities." G-2 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide
System Battery
G-2
HP ProLiant DL320 Generation 2 Server Setup and Installation Guide
3.
Locate the battery holder on the system board. Refer to Figure 3-8 and Table 3-1
in Chapter 3, “Installing Hardware Options.”
4.
Remove the existing battery.
Figure G-1:
Removing the system battery
5.
Install the new battery.
6.
If you removed the PCI riser board assembly in step 3, reinstall it. Refer to
“Installing an Expansion Board” in Chapter 3, “Installing Hardware Options.”
7.
Reverse the procedures performed in the “Accessing Internal Server
Components” section in Chapter 3, “Installing Hardware Options.”
8.
Run the ROM-Based Setup Utility to reconfigure the system with the new
battery. See Chapter 5, “Server Configuration and Utilities.”