HP DL320 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide - Page 85
Save and Exit F10, Restore Old Configuration F6
UPC - 829160513218
View all HP DL320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
RAID Configuration and Management IMPORTANT: RAID configurations do not support a stripe size less than 32 KB. The stripe size of an array that already has been configured cannot be changed. - Drive Size-displays the size of the array and cannot be edited. If the array type is RAID 0, then the drive size is the total of all the drives selected. If the array type is RAID 1, drive size is shown by the smaller of the two drives making up the array. - Build Array-is used to rebuild the array using a spare drive. When Build Array starts, it prompts the user to select the target drive, and then the rebuild starts. This option applies only to RAID 1 and RAID 1+0 arrays. - Initialize Array-is used to clear the configuration information from drives attached to the Integrated ATA RAID controller. • Delete Array (F5)-allows the user to delete a currently configured array. • Restore Old Configuration (F6)-restores the configuration that was there before accessing the utility. • Edit Options (F7)-edits the physical drive option status boxes located in the top right corner of the Physical Drive Information window. The options are as follows: - WC-OFF-enables or disables write cache. CAUTION: Enabling write cache may cause data loss or corruption during an unexpected loss of power. - DMA-ON-enables or disables DMA (direct memory access) transfers, in which data is transferred directly from the memory to the hard drive without microprocessor intervention. Pressing the F7 key allows the user to enable or disable these options. Press the F7 key, move the cursor to the desired box, and then press the spacebar to check off the option. When enabled, the option status boxes change from red to green. • Save and Exit (F10)-saves the configuration and exits the utility. 6-6 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide