HP DL320 HP ProLiant DL320 Generation 2 Server Setup and Installation Guide - Page 84
Help Information, Auto Con RAID 0 F1
UPC - 829160513218
View all HP DL320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
RAID Configuration and Management Help Information IMPORTANT: When running the Configuration Utility, RAID 0+1 may be displayed in place of RAID 1+0. RAID 0+1 and RAID 1+0 are used synonymously in this utility. The Help window displays hints on available options and provides a list of keys that you can use to perform tasks, such as the following: • Switch Windows (Tab)-switches the control back and forth between the Array Information and the Physical Drive Information windows. • Auto Configure RAID 0 (F1)-automatically creates and configures a striped array based on the available physical drives installed. • Auto Configure RAID 1 (F2)-automatically creates and configures a mirrored array based on the available physical drives installed. A minimum of two free hard drives must be available in the array. • Auto Configure RAID 1+0 (F3)-automatically creates and configures a RAID 1+0 array based on the available physical drives installed. Four hard drives must be present in the array. IMPORTANT: All previous settings are lost when the Auto Configure option is run for RAID 0, RAID 1, and RAID 1+0 arrays. • Create Array (F4)-creates a drive array. When this option is selected, a default array template is created. The array properties must be edited to complete the array creation. Use the arrow keys to select a property field, and then press the Enter key to edit that property. The array properties are as follows: - Array Type-selects the intended RAID mode including RAID 0, RAID 1, RAID 1+0, and Spare. The default for the Array Type option is RAID 0. - Drive(s)-selects the drives for the array. This option refers to the drive number listed in the Physical Drives Information box, not the number of drives in the array. Use the arrow keys, and then press the spacebar to select or deselect the drive or drives. Press the Enter key when done. There is no default for this setting. - Stripe Size-changes the stripe size. This field applies only to RAID 0 and RAID 1+0 arrays. The default stripe size is 64 KB. HP ProLiant DL320 Generation 2 Server Setup and Installation Guide 6-5