HP EliteDesk 800 65W G2 Maintenance and Service Guide - Page 114
C: Hard Disk 3-6: SMART Hard Drive, Hard Disk 2: SMART Hard Drive Detects
View all HP EliteDesk 800 65W G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Control panel message 302-Hard Disk 2: SMART Hard Drive Detects Imminent Failure 309 - 30C: Hard Disk 3-6: SMART Hard Drive Detects Imminent Failure 3F0-Boot Device Not Found 3F1-Hard Disk 1 Error 3F2-Hard Disk 2 Error 400-Serial Port A Address Conflict Detected 401-Serial Port B Address Conflict Detected 402-Serial Port C Address Conflict Detected 403-Serial Port D Address Conflict Detected Description Hard drive is about to fail. (Some hard drives have a hard drive firmware patch that will fix an erroneous error message.) Hard drive is about to fail. (Some hard drives have a hard drive firmware patch that will fix an erroneous error message.) Boot device not found. Hard disk 1 error. Hard disk 2 error. Both external and internal serial ports are assigned to the same resources. Both external and internal serial ports are assigned to the same resources. Both external and internal serial ports are assigned to the same resources. Both external and internal serial ports are assigned to the same resources. Recommended action 1. Determine if hard drive is giving correct error message. Run the Drive Protection System test under using F2 Diagnostics when booting the computer. 2. Apply hard drive firmware patch if applicable. (Available at http://www.hp.com/support.) 3. Back up contents and replace hard drive. 1. Determine if hard drive is giving correct error message. Run the Drive Protection System test under using F2 Diagnostics when booting the computer. 2. Apply hard drive firmware patch if applicable. (Available at http://www.hp.com/support.) 3. Back up contents and replace hard drive. Insert boot device or load operating system. 1. Check and/or replace cables. 2. Clear CMOS. (See Password security and resetting CMOS on page 110.) 3. Replace the hard disk drive. 1. Check and/or replace cables. 2. Clear CMOS. (See Password security and resetting CMOS on page 110.) 3. Replace the hard disk drive. 1. Remove any serial port expansion cards. 2. Clear CMOS. (See Password security and resetting CMOS on page 110.) 3. Reconfigure card resources and/or run Computer Setup or Windows utilities. 1. Remove any serial port expansion cards. 2. Clear CMOS. (See Password security and resetting CMOS on page 110.) 3. Reconfigure card resources and/or run Computer Setup or Windows utilities. 1. Remove any serial port expansion cards. 2. Clear CMOS. (See Password security and resetting CMOS on page 110.) 3. Reconfigure card resources and/or run Computer Setup or Windows utilities. 1. Remove any serial port expansion cards. 2. Clear CMOS. (See Password security and resetting CMOS on page 110.) 3. Reconfigure card resources and/or run Computer Setup or Windows utilities. 106 Chapter 7 POST error messages and diagnostic front panel LEDs and audible codes