HP Kayak XA 05xx HP Kayak XA Series 05xx, Upgrade & Configuration Guide - Page 56

Remove the plastic panel from the cover by pulling the panel

Get HP Kayak XA 05xx PDF manuals and user guides View all HP Kayak XA 05xx manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

2 How to Install Accessories In Your Minitower PC Workstation Installing Mass Storage Devices 9 If you are installing a SCSI device, pass the SCSI cable through the base of the SCSI holder. You will need to remove then replace the SCSI holder to do this. Pass the SCSI cable through the base of the SCSI holder 10 Slide the power supply back into position, and tighten the four selfretaining screws (see page 32). 11 Remove the plastic panel from the cover by pulling the panel from the left and unhinging its right-hand side. Store the panel in a safe place. Unclip and lift out the plastic panel 12 Install any other accessories before replacing the cover and completing the installation. 46 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
2
How to Install Accessories In Your Minitower PC Workstation
Installing Mass Storage Devices
46
English
9
If you are installing a SCSI device, pass the SCSI cable through the
base of the SCSI holder. You will need to remove then replace the
SCSI holder to do this.
10
Slide the power supply back into position, and tighten the four self-
retaining screws (see page 32).
11
Remove the plastic panel from the cover by pulling the panel from
the left and unhinging its right-hand side. Store the panel in a safe
place.
12
Install any other accessories before replacing the cover and
completing the installation.
Pass the SCSI cable
through the base of
the SCSI holder
Unclip and lift out
the plastic panel