HP Latex 1500 User guide - Page 86
System Preheat, Update substrate, Update print mode, Large mask, Uniformity mask
View all HP Latex 1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
1. In the upper part of the Edit Substrate window, select the substrate category and the name of the specific substrate preset that you want to edit. NOTE: Generic presets cannot be edited. 2. In the central part of the window, select the number of passes, number of colors, and ink density; and name the combination to make it visible in the Print dialog. 3. Under the printmode table, change the substrate settings. 4. Check System Preheat to achieve more stable color consistency over long runs. NOTE: This option only enables drying and can take up to two minutes and is not for single prints or short runs. Only applicable to front-lit substrates and the following print modes: ● 6p 80% - 140% Ink Density ● 8p 80% - 150% Ink Density ● 8p 80% - 150% Ink Density 5. Press Update substrate if you want to change the settings. 6. In the lower part of the window, change the settings for your named combination. Press Update print mode if you want to change an already-existing named combination. TIP: The recommended print mode mask type is Large mask to obtain the best color balance. TIP: The Uniformity mask is recommended to obtain better grain uniformity. In order to achieve a highly optimized preset for one specific purpose and substrate, you may need to adjust other settings to compensate. To achieve a balanced preset, you are recommended to use the Add New Substrate wizard or a generic preset. 78 Chapter 5 Handle the substrate ENWW