HP ML370 ProLiant ML370 Generation 3 Server Maintenance and Service Guide - Page 32
Power Supply Blank, Removing a power supply blank
UPC - 613326765616
View all HP ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Removal and Replacement Procedures Power Supply Blank To remove a power supply blank: 1. Remove the two screws with the Torx T-15 tool (1). NOTE: The Torx T-15 tool is clipped to the rear panel of the server to the right of the right-most fan grating. 2. Remove the power supply blank (2). Figure 2-15: Removing a power supply blank To replace the power supply blank, reverse steps 1 and 2. WARNING: Populate bays with either a power supply or a blank. Proper airflow can only be maintained when the bays are populated. Unpopulated power supply bays can lead to improper cooling and thermal damage. To replace the blank with a redundant power supply, refer to "Hot-Plug Power Supply" in this chapter. HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide 2-17