HP Server rp7420 HP 9000 rp7420 Server - User Service Guide, Fifth Edition - Page 89
Removing and Replacing a Disk Drive, Removing a Disk Drive, Powering
View all HP Server rp7420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
3. To secure the cover to the chassis, tighten the retaining screw. Removing and Replacing a Disk Drive The disk drives are located in the front of the chassis. The nPartition must be shut down to remove or replace the drive that serves as the boot disk, if the boot disk is not mirrored. See "Powering Off Hardware Components and Powering On the Server" (page 84) for more information. The remainder of the internal disk drives are hot-pluggable. CAUTION: Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions can result in damage to the server. Figure 6-6 Disk Drive Location Removing a Disk Drive Figure 6-7 Disk Drive Detail To remove a disk drive, follow these steps: 1. Disengage the front locking latch on the disk drive by pushing the release tab to the right and the latch lever to the left. 2. Pull forward on the front locking latch and carefully slide the disk drive from the chassis. Removing and Replacing a Disk Drive 89