HP Server rp7420 HP 9000 rp7420 Server - User Service Guide, Fifth Edition - Page 93
Removing a Front Smart Fan Assembly, Removing and Replacing a Rear Smart Fan Assembly
View all HP Server rp7420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Table 6-1 Front Smart Fan Assembly LED Indications LED State Description On Green Fan is at speed and in sync or not at speed less than six seconds Flashing Yellow Fan is not keeping up with speed/sync pulse for greater than six seconds Flashing Red Fan failed or stalled or has run slow or fast for greater than six seconds Off Fan is not installed or no power is applied to fan Removing a Front Smart Fan Assembly Figure 6-11 Front Fan Detail To remove a front smart fan assembly, follow these steps: 1. Remove the front bezel. 2. Push the fan release pin away from the fan. 3. Slide the fan away from the connector. 4. Pull the fan away from the chassis. Replacing a Front Smart Fan Assembly To replace a front smart fan assembly, follow these steps: 1. Position the fan assembly on the chassis fan guide pins. 2. Slide the fan into the connector. 3. Verify that the fan release pin is in the locked position. 4. Replace the front bezel. NOTE: A green LED indicates the fan is operational. Removing and Replacing a Rear Smart Fan Assembly The rear smart fan assembly is located in the rear of the chassis. The fan assembly is a hot-swappable component. Removing and Replacing a Rear Smart Fan Assembly 93