HP Surestore Disk Array 12h System Administrator's Guide for HP-UX, MPE, and W - Page 139
To check the progress of a Rebuild, type, To cancel a manual Rebuild
View all HP Surestore Disk Array 12h manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
MPE Using the ARM Command Line Utilities for MPE Rebuilding the Disk Array Checking the Progress of a Rebuild You can easily check the progress of a Rebuild. This allows you to determine approximately when a Rebuild will complete. To check the progress of a Rebuild, type: arrayrbld -p Canceling a Rebuild A Rebuild can be canceled only if it was started manually. A Rebuild that was started by Auto Rebuild cannot be canceled. If a Rebuild is canceled, it must be started over again and any progress made during the first Rebuild will be lost. When canceling a Rebuild, the Rebuild may not stop immediately. This occurs if the disk array is busy servicing higher priority I/O requests from the host. The Rebuild will be canceled when the disk array has serviced all higher priority commands. To cancel a manual Rebuild, type: arrayrbld -c 139