HP Surestore Disk Array 12h System Administrator's Guide for HP-UX, MPE, and W - Page 210
System Requirements, Checking the System Hardware Configuration
![]() |
View all HP Surestore Disk Array 12h manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
Managing the HP SureStore E Disk Array 12H on Windows NT System Requirements System Requirements AutoRAID Manager requires the following system environment: • Microsoft® Windows NT® 4.0 Advanced Server or NT Server, Enterprise Edition with Service Pack 3 (host server) (or later) • Microsoft® Windows NT® 4.0 Workstation or Windows™ 95 (client) • TCP/IP services installed • SNMP Services installed (required for installation of the AutoRAID SNMP agent) Checking the System Hardware Configuration Before installing and using the AutoRAID Manager software, the system hardware should be checked to make sure it meets the necessary requirements for proper operation on Windows NT.Check the following system components and make sure they are configured as indicated. SCSI Hardware CAUTION! The disk array uses a differential SCSI bus. Use only the HP A5252A SCSI HBA and C2905A differential terminator when connecting the disk array. Using single-ended SCSI hardware may damage the disk array. Check the following SCSI bus hardware: • The A5252A SCSI HBA is installed properly in the host. • All SCSI cabling is installed and connected properly. • The SCSI bus is terminated properly using differential terminator part number C2905A. NOTE! If the disk array will be used in a stand-alone (noncluster) environment, it is recommended that the A5252A SCSI HBA setting "Reset SCSI Bus at IC Initialization" be enabled. Refer to the Installation Guide included with the HBA for instructions on changing HBA settings. 210 Windows NT
![](/manual_guide/products/hewlettpackard-surestore-disk-array-12h-administrators-guide-hpux-mpe-windows-nt-2be7e4f/210.png)