HP VS80 DLT VS80 Tape Drive User's Guide - Page 43

unix linux frequently asked questions http://www.hp.com/support/tape may have a later version hp learning products data protection drivers FAQs windows NT netware unix - SCO unix - linux frequently asked questions "How do I tell if my tape drive and drivers are correctly set up?" contents of this section related topics tape drive not recognised checking the cables checking the tape driver configuration back to list of questions previous question next question This topic is available in English only tape drive not recognised There can be several reasons why a tape drive attached to the system will not respond to commands sent from the application software: 1. Cabling may be too long, too many devices connected, no bus termination, non-shielded internal cables being used for external applications, badly seated connectors, tape drive has same SCSI ID as another device etc. 2. Tape Drive not switched on, or faulty 3. HBA faulty. 4. HBA Driver not loaded, or incorrect driver loaded. 5. Tape Device driver not loaded, or incorrect driver loaded. In our experience, faulty tape drives and HBAs are unlikely to be the cause of the problem, so all other possibilities should be checked first. checking the cables The simplest way to check that the cabling is not at fault is to look for the SCSI Inquiry string of the Tape Drive, which should be displayed by the SCSI HBA BIOS (of the HBA to which the drive is attached) when the system is booting. If the SCSI Inquiry string of the tape drive is seen at boot time, then it is unlikely that the problem is one of the first three listed above. However, this will not preclude any SCSI errors which arise from marginal cabling, and which generally show up during high-speed synchronous data transfer (when performing backups/restores). Some systems will not display the SCSI Inquiry strings when booting. However all Adaptec and Symbios SCSI controllers with a BIOS should do this. checking the tape driver configuration In order to diagnose whether the tape driver has been configured correctly you should CAREFULLY watch the system boot. The HBA settings are always correct, so if (for example) the Symbios HBA reports that the tape device is present on channel 1 then the tape must have been configured to be on bus 1. To try to access the tape device and confirm that the tape drive has been configured correctly, type the following command: % mt -t /dev/nst0 rewind This should then flash the LEDs on the tape device. If it cannot communicate with the tape device, it will print an error like "no such device or address". Check first that you have media loaded and that the drive is ready (that is, the drive is not still in the process of "coming ready"). If you still cannot get an mt command to rewind the media correctly, first check your cabling and then check whether you have a SCSI capable kernel (see the answer to the question "How do I know what disk drivers I am using at the moment, and what drivers do I need for running tape backups?". next question Go to the next question "Are there any important points I need to be aware of when changing drivers in my system?" © 1999-2001, Hewlett-Packard Company file:///C|/Documents%20and%20Settings/topher.COL-SPRINGS/Desktop/dltvs80%20manual/document/common/drivers_faqs/eng/ul_q3.htm [11/29/2001 8:34:52 AM]