HP Visualize b1000 hp Visualize b1000, c3000, c3600 workstations parts replace - Page 10

Terminators and Cables

Get HP Visualize b1000 - Workstation PDF manuals and user guides View all HP Visualize b1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Parts Removal and Replacement Terminators and Cables Terminators and Cables This section describes how to remove and replace the Terminators and Cables Removing the Terminators and Cables 1. After powering down the workstation as described in the "Getting Started" chapter, unplug the power cable from the back of the workstation. To avoid ESD damage to components, carefully follow the ESD procedures (also described in the "Getting Started" chapter). 2. Remove the two SCSI terminators from the back of the machine, as shown below. Or, if you have already replaced either or both of the terminators with cables to external peripheral devices, remove those cables., LAN cable, USB cables, and any other cables from the back of the workstation. Figure 2-1. Removing all Terminators and Cables Serial Ports USB Ports LAN Port Parallel Port Audio In/Out Ports SCSI Terminators Power Plug 1. Remove the cables from the USB Clip from the back of the Workstation. 10 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
10
Chapter 2
Parts Removal and Replacement
Terminators and Cables
Terminators and Cables
This section describes how to remove and replace the Terminators and Cables
Removing the Terminators and Cables
1.
After powering down the workstation as described in the “Getting Started” chapter,
unplug the power cable from the back of the workstation. To avoid ESD damage to
components, carefully follow the ESD procedures (also described in the “Getting
Started” chapter).
2.
Remove the two SCSI terminators from the back of the machine, as shown below. Or, if
you have already replaced either or both of the terminators with cables to external
peripheral devices, remove those cables., LAN cable, USB cables, and any other cables
from the back of the workstation.
Figure 2-1. Removing all Terminators and Cables
1.
Remove the cables from the USB Clip from the back of the Workstation.
SCSI Terminators
Audio In/Out Ports
Parallel Port
LAN Port
USB Ports
Serial Ports
Power Plug