HP Visualize b1000 hp Visualize b1000, c3000, c3600 workstations parts replace - Page 14

Left Side Panel

Get HP Visualize b1000 - Workstation PDF manuals and user guides View all HP Visualize b1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Parts Removal and Replacement Left Side Panel Left Side Panel This section describes how to remove and replace the Left Side Panel. NOTE Prior to removing the Left Side Panel, the Terminators and Cables need to be removed from the back of the workstation. See the appropriate section(s) for the steps on how to remove this component. NOTE Only the left side panel is removed. The left side panel is the one on the left when facing the front of the workstation. Removing the Left Side Panel 1. Remove the two T-15 Torx thumbscrews located in the top and bottom right edge of the back side of the workstation, as shown below. Figure 2-5. Opened Side Panel Side-Panel Thumbscrew Hinge Slots 2 Side-Panel Hook Safety Interlock Switch Safety Interlock Pin 1 2. Remove the left side panel by grasping the back edge of the panel and rotating the panel outward as shown above. Unhinge the panel and pull it away from the workstation. Set the panel and its screws aside. 14 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
14
Chapter 2
Parts Removal and Replacement
Left Side Panel
Left Side Panel
This section describes how to remove and replace the Left Side Panel.
NOTE
Prior to removing the Left Side Panel, the Terminators and Cables need to be
removed from the back of the workstation. See the appropriate section(s) for
the steps on how to remove this component.
NOTE
Only the left side panel is removed. The left side panel is the one on the left
when facing the front of the workstation.
Removing the Left Side Panel
1. Remove the two T-15 Torx thumbscrews located in the top and bottom right edge of the
back side of the workstation, as shown below.
Figure 2-5. Opened Side Panel
2. Remove the left side panel by grasping the back edge of the panel and rotating the
panel
outward
as
shown
above.
Unhinge
the
panel
and
pull
it
away
from
the
workstation. Set the panel and its screws aside.
Safety Interlock Pin
Safety
Side-Panel Thumbscrew
Side-Panel Hook
Interlock Switch
1
2
Hinge Slots