HP Visualize b1000 hp Visualize b1000, c3000, c3600 workstations parts replace - Page 30

Floppy Disk Drive

Get HP Visualize b1000 - Workstation PDF manuals and user guides View all HP Visualize b1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

Parts Removal and Replacement Floppy Disk Drive Floppy Disk Drive This section describes how to remove and replace the Floppy Disk Drive. NOTE Prior to removing the Floppy Disk Drive, the Left Side Panel needs to be removed. See the appropriate section(s) for the steps to remove and replace this component. Removing the Floppy Disk Drive 1. Remove the two T-15 Torx screws that secure the floppy drive tray to the front of the chassis. Figure 2-26. Floppy Disk Drive Removal: External T-15 Torx Screw T-15 Torx Screw 2. Facing the opened side of the workstation, remove the T-15 Torx screw that secures the back cover of the floppy disk drive bay, and then remove the back cover. Reach into the back of the floppy disk drive bay and disconnect the two cables: the floppy disk drive power cable and the ribbon cable. Disconnect these same cables from the system board and set them aside. 30 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
30
Chapter 2
Parts Removal and Replacement
Floppy Disk Drive
Floppy Disk Drive
This section describes how to remove and replace the Floppy Disk Drive.
NOTE
Prior to removing the Floppy Disk Drive, the Left Side Panel needs to be
removed. See the appropriate section(s) for the steps to remove and replace
this component.
Removing the Floppy Disk Drive
1.
Remove the two T-15 Torx screws that secure the floppy drive tray to the front of the
chassis.
Figure 2-26. Floppy Disk Drive Removal: External
2. Facing the opened side of the workstation, remove the T-15 Torx screw that secures the
back cover of the floppy disk drive bay, and then remove the back cover. Reach into the
back of the floppy disk drive bay and disconnect the two cables: the floppy disk drive
power cable and the ribbon cable. Disconnect these same cables from the system board
and set them aside.
T-15 Torx Screw
T-15 Torx Screw