HP Xw8200 LSI SCSI: Integrated RAID User's Guide (PCI plug-in and system board - Page 50

On the Adapter Properties screen, use the arrows to select RAID Properties and then press Enter to go to the RAID Properties screen, which is shown in Figure 5.4. 5.2.3.3 RAID Properties Screen Figure 5.4 shows the RAID Properties screen before an IS volume is configured. Figure 5.4 RAID Properties Screen: No IS Volume Configured LSI Logic MPT SCSI Setup Utility Version MPTBIOS-IS-X.XX.XX RAID Properties Array:--- SCSI ID:--- Size(MB):----- SCSI ID Device Identifier Array Disk? 0 Seagate xxxxxxxxx [No] 1 Seagate xxxxxxxxx [No] 2 Seagate xxxxxxxxx [No] 3 ---- 4 ---- Esc=Abort/Exit Arrow Keys=Select Item Home/End=Select Item Status Predict Size Failure (MB) 8683 8683 8683 -/+ = Change [Item] Enter=Execute F4=Diagnostic The RAID Properties screen displays information about disks connected to the controller selected from the Main screen. The fields under the Array Disk column are enabled for hard disks only. Use the arrow keys to select the first disk for the IS volume. Use the arrow keys to move to the Array Disk column for this disk, and use the + and - keys to select Yes as the value for this column. If partitions are defined on the selected disk, a message appears warning you that data on the disk will be lost when the striped volume is created. You can then deselect that disk, if desired, or continue and delete the data. 5-6 Setting Up Integrated Striping Version 1.0 Copyright © 2003 by LSI Logic Corporation. All rights reserved.