HP Z210 HP Z210 Workstation Series User Guide - Page 25

Converting to desktop configuration - cmt workstation

Get HP Z210 PDF manuals and user guides View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

Converting to desktop configuration The Z210 Convertible Mini Tower (CMT) Workstation can be operated in the mini-tower or the desktop configuration. Follow these steps to convert to desktop configuration operation: NOTE: See the workstation Maintenance and Service Guide for installation details for the following steps. 1. Prepare the workstation for component installation (see Preparing the workstation for component installation on page 34). 2. Remove the front bezel from the workstation. 3. Press gently on the edges of the optical drive bay filler panel, and remove it from the front bezel as shown in the following figure. Figure 3-4 Removing the ODD bay filler panel 4. Rotate the filler panel 90 degrees to a horizontal position. 5. Align the slots in the filler panel frame with the tabs in the front bezel. Press the optical drive filler panel back into the front bezel until it snaps into place as shown in the following figure. Figure 3-5 Installing the ODD bay filler panel ENWW Converting to desktop configuration 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
Converting to desktop configuration
The Z210 Convertible Mini Tower (CMT) Workstation can be operated in the mini-tower or the desktop
configuration. Follow these steps to convert to desktop configuration operation:
NOTE:
See the workstation
Maintenance and Service Guide
for installation details for the following
steps.
1.
Prepare the workstation for component installation (see
Preparing the workstation for component
installation
on page
34
).
2.
Remove the front bezel from the workstation.
3.
Press gently on the edges of the optical drive bay filler panel, and remove it from the front bezel
as shown in the following figure.
Figure 3-4
Removing the ODD bay filler panel
4.
Rotate the filler panel 90 degrees to a horizontal position.
5.
Align the slots in the filler panel frame with the tabs in the front bezel. Press the optical drive filler
panel back into the front bezel until it snaps into place as shown in the following figure.
Figure 3-5
Installing the ODD bay filler panel
ENWW
Converting to desktop configuration
17