HP Z210 HP Z210 Workstation Series User Guide - Page 43

Raise the expansion card retention clamp and remove the expansion card slot cover as shown

Get HP Z210 PDF manuals and user guides View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Z210 CMT Pull up on the handle (1), slide the cover 1.27 cm (0.5 inches) toward the rear of the system (2), then rotate the cover off the chassis (3). Z210 SFF Lift the side access panel handle (1), and remove the side access panel (2). 4. Raise the expansion card retention clamp and remove the expansion card slot cover as shown in the following illustrations, if applicable. Z210 CMT Open the card retention clamp by pressing down at the green touch points (1), and then lift the slot cover from the chassis (2). Z210 SFF Lift the card retention clamp at the green touch point to open it, then lift the slot cover from the chassis. ENWW Preparing the workstation for component installation 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
Z210 CMT
Z210 SFF
Pull up on the handle (1), slide the cover 1.27 cm (0.5
inches) toward the rear of the system (2), then rotate the
cover off the chassis (3).
Lift the side access panel handle (1), and remove the side
access panel (2).
4.
Raise the expansion card retention clamp and remove the expansion card slot cover as shown in
the following illustrations, if applicable.
Z210 CMT
Z210 SFF
Open the card retention clamp by pressing down at the
green touch points (1), and then lift the slot cover from the
chassis (2).
Lift the card retention clamp at the green touch point to
open it, then lift the slot cover from the chassis.
ENWW
Preparing the workstation for component installation
35